Download this free 3D print file designed by DIY Wizard. Welcome back witches and wizards!Since I love making magic wands so much, I created another one! I have this model laying around for several years now. It was a single version before and I liked it, becaus it ws thin, but then I decided to make it fully customisable / modular, so you can fully create you own design with different handles, shafts, end knobs and top knobs! So make your personal wand like you imagine it after seeing harry potter ^^And of course it's collapsible with that favourite sound! It is also a great fidget toy! Boost MeThese models take a lot of time so I appreciate boosts very much to buy new filament or printer parts :)How to print? I highly recommend using my print profiles. I thought it would be best to but all handles, shafts, end & top knobs in one print profile, so you can print them all and choose while builing, it would be a lot of work to make a print profile for all single parts. The parts don't need that much filament and time.Important settings:Handles:But the with the bigger thread on the built plateactivate arachne wall mode0.2mm layer height or smalleractive automatic tree supports Shafts:the shafts are the hardest to print and may cause failure if not being careful!Activate arachne wall mode, otherwise parts might float in mid air!outer brim is highly recommended!0.2mm layer height works finenormal speed works, I wouldnt use sport or ludacrous mode!for me it always works fine to print the 3 parts at onceMAKE SURE YOUR PRINT BED IS CLEAN and you have the best possible bed adhesion! I highly recommend super tack built plate (I personally prefer frostbite) or glue.Yes the shafts are thin and break easy! This is a magic wand to be very careful with. I have designed many collapsing wands in my life, it doesn't make much difference, even if the shaft pieces consist of 2 walls they break easily. There is just a high lever on the layer lines when swinging or bending it, so it snap easily. I wanted the whole wand to be as thin as possible.KnobsThey are in general easy to printactivate arachne wall mode!I suggest 0.12mm layer height or below for high detailsthe ones with overhangs need tree support, the others don't need any support Assembly:Assembly is easy:Screw a top knob on the thinner side of the handlePut the 3 shaft pieces into the handle (from the bigger side of the handle)Screw on the end knob! I wish you happy printing and a lot of fun with my wands. Please note that they are under standard digital file license which doesn't allow remixing, reuploading or commercial usage of my model.BUT:If you come up with any personal designs for knobs or handles, you may upload them here as a print profile. I will review them and contact you if I see any problems.